Surface Chemical Analysis - Atomic force microscopy - Procedure for in situ characterization of AFM probe shank profile used for nanostructure measurement
Introduction: Atomic force microscopes (AFMs) are of increasing importance for imaging surfaces at the nanoscale. The imaging mechanism involves a dilation of the surface form by the AFM probe shape. In practice, the radii of probe tips are in the range of 1 nm to 200 nm, which is the same order of magnitude as that of many important surface features. AFM images may, therefore, be strongly affected by the shape and size of the AFM probe used for imaging. In addition, the mechanism used to control the distance between the AFM probe and the sample surface can create artefacts in AFM images, because the effective probe shape characteristic depends on the control parameters. The probe radius and its half-cone angle are often used for the specification of AFM probes. However, practical probes are often not described so simply. Therefore, a quantitative expression for probe shank shape is required. This International Standard describes two methods for the detailed determination of probe shank shape: a projection of the probe profile (PPP) and the effective probe shape characteristic (EPSC), both of which are projected onto a defined plane and which, in turn, include the effect of the probe controlling mechanism. The PPP provides a continuous profile, whereas the EPSC provides a few discrete characteristic points. PPP, used in conjunction with a probe shape characteristic (PSC) measurement, gives the quality of the probe for general applications, whereas EPSC indicates the usefulness of the probe
Scope: This International Standard specifies two methods for characterizing the shape of an AFM probe tip, specifically the shank and approximate tip profiles. These methods project the profile of an AFM probe tip onto a given plane, and the characteristics of the probe shank are also projected onto that plane under defined operating conditions. The latter indicates the usefulness of a given probe for depth measurements in narrow trenches and similar profiles. This International Standard is applicable to the probes with radii greater than 5u0, where u0 is the uncertainty of the width of the ridge structure in the reference sample used to characterize the probe.
Contents:
- Foreword
- Introduction
- Scope