ISO 13099-3-2014 PDF

ISO 13099-3-2014 PDF

Colloidal systems - Methods for zeta potential determination - Part 3: Acoustic methods

$96.50 $193.00 -50%
Product Code: ISO 13099-3
Stock In Stock
Edition: 1ST
Published: 07/01/2014
Number of Pages: 28
File Size: 1 file, 590 Bytes

Available Options

Product Description

Colloidal systems - Methods for zeta potential determination - Part 3: Acoustic methods

Introduction: Zeta potential is a parameter that can be used to predict the long term stability of suspensions and emulsions, and to study surface morphology and surface adsorption of particles and other surfaces in contact with a liquid. Zeta potential is not a directly measurable parameter. It can be determined using appropriate theoretical models from experimentally determined parameters, which depend on electric charge separation at interfaces. “Electrokinetic phenomena” encompass such experimentally observed effects. A group of electrokinetic phenomena at high frequency on MHz scale is referred to as “electroacoustics”.[1] Each classical electrokinetic phenomenon at DC or low AC conditions has electroacoustic analogue. These electroacoustic phenomena have been widely used to determine electrophoretic mobility of various concentrated particulates without sample dilution. The purpose of this part of ISO 13099 in methods for Zeta potential determination is description of general features of such electroacoustic methods that should be common for all instrumental implementation for measuring electrophoretic mobility using electroacoustics and following calculation of zeta potential of particulates. © ISO 2014 – All rights reserved

Scope: This part of ISO 13099 describes in general electroacoustic effects that can be defined as high frequency electrokinetic phenomena. Particular attention is given to two methods of measurement of electrophoretic mobility of particles suspended in a liquid at high concentration above 1 % v/v, colloid vibration current (CVI)[2] and electric sonic amplitude (ESA),[3] [4] respectively. Estimation of surface charge and determination of zeta potential can be achieved from measured electrophoretic mobility using proper theoretical models, which are described in detail in ISO 13099-1.

Contents:

  • Foreword
  • Introduction
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13099-3-2014 PDF

ISO 13099-3-2014 PDF

$96.50 $193.00