Water quality — Radon-222 — Part 4: Test method using two-phase liquid scintillation counting
Introduction: Radionuclides are present throughout the environment; thus, water bodies (e.g., surface waters, ground waters, sea waters) contain radionuclides, which can be of either natural or anthropogenic origin: — naturally-occurring radionuclides, including 3H, 14C, 40K and those originating from the thorium and uranium decay series, in particular 210Pb, 210Po, 222Rn, 226Ra, 228Ra, 227Ac, 231Pa, 234U, and 238U, can be found in water bodies due to either natural processes (e.g. desorption from the soil, runoff by rain water) or released from technological processes involving naturally occurring radioactive materials (e.g. mining, mineral processing, oil, gas, and coal production, water treatment and the production and use of phosphate fertilisers); — anthropogenic radionuclides such as 55Fe, 59Ni, 63Ni, 90Sr, 99Tc, transuranic elements (e.g., Np, Pu, Am, and Cm), and some gamma emitting radionuclides such as 60Co and 137Cs can also be found in natural waters. Small quantities of anthropogenic radionuclides can be discharged from nuclear facilities to the environment as a result of authorized routine releases. The radionuclides present in liquid effluents are usually controlled before being discharged to the environment [1] and water bodies. Anthropogenic radionuclides used in medical and industrial applications can be released to the environment after use. Anthropogenic radionuclides are also found in waters due to contamination from fallout resulting from above-ground nuclear detonati
Scope: This document describes a test method for the determination of radon-222 (222Rn) activity concentration in non-saline waters by extraction and liquid scintillation counting. The 222Rn activity concentrations, which can be measured by this test method utilizing currently available instruments, are above 0,5 Bq·l−1 which is the typical detection limit for a 10 ml test sample and a measuring time of 1 h. It is the responsibility of the laboratory to ensure the validity of this test method for water samples of untested matrices. Annex A gives indication on the necessary counting conditions to meet the required detection limits for drinking water monitoring.