ISO 13180-1-2026 PDF

ISO 13180-1-2026 PDF

Fibre-reinforced cementitious composites (FRCCs)-Direct tensile test method-Part 1: Strain hardening FRCCs

$48.00 $96.00 -50%
Product Code: ISO 13180-1
Stock In Stock
Edition: 26#
Published: 05/2026
Number of Pages: 16
File Size: 1 file, 540 KB

Available Options

Product Description

Fibre-reinforced cementitious composites (FRCCs) — Direct tensile test method — Part 1: Strain hardening FRCCs

Introduction: Strain hardening fibre-reinforced cementitious composites (FRCCs) have been demonstrated to have superior tensile strength, ductility, energy absorption capacity and fracture toughness compared to normal concrete. Strain hardening FRCCs include high performance fibre-reinforced cementitious composites (HPFRCCs)[1,2], engineered cementitious composites (ECCs)[3,4] and ultra-high-performance fibre-reinforced concretes (UHPFRCs)[5-9]. The superior mechanical and material resistance of strain hardening FRCCs compared to normal concrete and strain softening FRCCs have motivated structural engineers to apply them to civil infrastructure and buildings[6,7,9,10]. Strain hardening is defined as the material behaviour observed over a specified tensile strain range following the initiation of cracking, in which the initial peak stress decreases or nonlinear behaviour begins, and the tensile stress subsequently increases to a value exceeding the initial cracking strength. Within the defined strain range, strain hardening is characterized by a monotonic increase in tensile stress with increasing strain. Local stress fluctuations or oscillations are not considered to satisfy the definition of strain hardening unless they are explicitly permitted and technically justified. This definition is intended to ensure an objective interpretation of test results and to enable clear identification of the peak tensile stress associated with strain-hardening behaviour. The use of strain hardening FRCCs

Scope: This document specifies a test method for evaluating direct tensile resistance of strain hardening fibre- reinforced cementitious composites (FRCCs) using tensile parameters. This test method provides tensile stress versus strain curve, first cracking strength, post cracking strength, strain capacity (strain at post cracking point), and the number of cracks within gauge length. This test method is primarily intended for use with FRCCs that exhibit strain hardening behaviour. This test method is not intended for materials that exhibit strain-softening behaviour.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13180-1-2026 PDF

ISO 13180-1-2026 PDF

$48.00 $96.00