Soil quality — Screening soils for selected elements by energy-dispersive X-ray fluorescence spectrometry using a handheld or portable instrument
Introduction: X-ray fluorescence spectrometry (XRF) using battery or active source-powered handheld or portable equipment is a quick method for the determination of total elemental compositions of soil samples. Unlike laboratory analyses by inductively coupled plasma optical emission spectroscopy (ICP-OES) and atomic absorption spectroscopy (AAS), XRF needs no digestion step to prepare a test solution to be analysed. Consequently, handheld or portable equipment of energy dispersive XRF (ED-XRF) is suitable for the rapid on-site determination of selected elements, mainly heavy metals, in screening processes. When performing analyses at a site, it can be important to have information on the presence of an element (qualitative analysis) and also to obtain results from semi-quantitative analysis. Typical elements that can be detected and measured are Cr, As, Se, Cd, Hg and Pb, depending on the instrument (the elements validated for XRF detection and measurement are listed in Note 3 in Clause 1). In these situations, factory pre-set calibrations are used. For quantitative results, complementary analysis by alternative means is needed. An ED-XRF exercise can comprise a single determination at one location, in accordance with the guidance in this document, several determinations, or a large number of determinations. Where XRF analysers are being used to assess concentrations of soil contaminants which are harmful to humans or the environment, or both, there can be applicable national regulations
Scope: This document specifies the procedure for screening soils for selected elements using handheld or portable equipment for energy dispersive X-ray fluorescence spectrometry (ED-XRF). It covers the application of this screening method to obtain qualitative or semi-quantitative data to assist decisions on a sampling strategy for detailed assessment of soil quality employing laboratory analytical chemical methods. NOTE 1 Screening methods generally provide qualitative or semi-quantitative concentration values that are indicative of concentration values, although occasionally they can give quantitative results under specific or limited conditions. NOTE 2 The greater the effort applied to the pretreatment of soil samples, the better the analytical results that can be expected (see e.g. Reference [19]). This document does not explicitly specify elements for which it is applicable, since the applicability depends on the performance of the apparatus and the objective of the screening. The elements which can be determined are limited by the performance of the instrument used, the concentrations of particular elements present in the soil, and the requirements of the investigation in terms of the minimum concentrations of concern (e.g. guideline value). NOTE 3 The XRF measurements of As, Cd, Co, Cr, Cu, Hg, Mo, Ni, Pb, Sb, Sn, V and Zn were validated as described in Annex A. NOTE 4 Annex B provides examples of when screening with a handheld ED-XRF spectrometer and a portable ED- XRF spectrometer can be useful. This document does not provide guidance on how to use the equipment to provide quantitative data for use in detailed site assessments. This document does not cover how the results of multiple determinations are synthesized to address the objectives of an ED-XRF determination. © ISO 2026 – All rights reserved ISO 13196:2026(en) 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 12404, Soil and wa