Systèmes de canalisations en plastique pour les branchements et les collecteurs d'assainissement enterrés sans pression — Poly(chlorure de vinyle) non plastifié (PVC-U), polypropylène (PP), polypropylène avec modificateurs minéraux (PP-MD) et polyéthylène (PE) — Spécifications relatives aux regards et aux boîtes d'inspection et de branchement dans les zones de circulation et dans les réseaux enterrés
Introduction: The inspection chamber or manhole covered by this document can be manufactured by various methods, e.g. injection moulding, rotational moulding, low-pressure moulding or fabricated from components made in accordance with other International Standards. The jointing of components can be achieved using: — elastomeric ring seal joints; — adhesive joints for PVC-U; — welded joints for PVC-U, PP and PE; — extrusion welding; — mechanical jointing. Both manholes and inspection chambers covered by this document can be site-assembled from different components but can also be manufactured as a single unit. In either case, the following functional parts can be recognized: a) base (always present); In the case of a one-piece chamber or manhole, the base part ends at a distance of 300 mm measured from the top of the main channel. b) riser (depth-dependent); c) telescopic part (design-dependent); d) cone (dependent on the design of near-surface components and their recommended installation); e) other near-surface components. © ISO 2026 – All rights reserved
Scope: This document specifies the definitions and requirements for buried circular manholes and inspection chambers installed to a maximum depth of 6 m from ground level to the invert of the main channel and manufactured from unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP), polypropylene with mineral modifiers (PP-MD) or polyethylene (PE). These products are intended for use in traffic areas and outside the building structure (application area code “U”) for wastewater (foul wastewater, domestic wastewater, surface water). NOTE 1 Products conforming with this document are also suitable in non-traffic areas. This document is only applicable to those chamber/manhole items where the manufacturer has clearly stated in the documentation how the components must be assembled to create a complete manhole or inspection chamber. The products covered by this document comprise the following: — products providing access to the drain or sewer systems by means of inspection and cleaning equipment. — products designated as manholes providing additionally human access to the drain or sewer systems. NOTE 2 Manholes and inspection chambers can be subject to national regulations and/or local provisions. NOTE 3 Products conforming with this document can be installed in underground applications without additional static calculations