Particle size analysis — Laser diffraction methods
Introduction: The laser diffraction technique has evolved such that it is now a dominant method for determination of particle size distributions (PSDs). The success of the technique is based on the fact that it can be applied to a wide variety of particulate systems. The technique is fast and can be automated, and a variety of commercial instruments is available. Nevertheless, the proper use of the instrument and the interpretation of the results require the necessary caution. Since ISO 13320-1:1999 was first published, the understanding of light scattering by different materials and the design of instruments have advanced considerably. This is especially marked in the ability to measure very fine particles. Therefore, it was replaced with the first edition of ISO 13320 in 2009, and since then the method has been developed for a wider application. Additionally, demands raised recently not only on establishment of accuracy of measurements but also on necessity of evaluation of the accuracy and of qualification of instrument by users. Therefore, this document incorporates the most recent advances in understanding. vi © ISO 2020 – All rights reserved
Scope: This document provides guidance on instrument qualification and size distribution measurement of particles in many two-phase systems (e.g. powders, sprays, aerosols, suspensions, emulsions and gas bubbles in liquids) through the analysis of their light-scattering properties. It does not address the specific requirements of particle size measurement of specific materials. This document is applicable to particle sizes ranging from approximately 0,1 µm to 3 mm. With special instrumentation and conditions, the applicable size range can be extended above 3 mm and below 0,1 µm. For spherical and non-spherical particles, a size distribution is reported, where the predicted scattering pattern for the volumetric sum of spherical particles matches the measured scattering pattern. This is because the technique assumes a spherical particle shape in its optical model. For non-spherical particles the resulting particle size distribution is different from that obtained by methods based on other physical principles (e.g. sedimentation, sieving).