Fans — Determination of fan sound power levels under standardized laboratory conditions — Part 4: Sound intensity method
Introduction: This document establishes a method for determining the sound power level of a fan. The method is reproducible in all laboratories which are qualified according to the requirements of this document. The method specified in this document employs standard sound measurement instrumentation. The test set-ups are generally designed to represent the physical orientation of a fan as installed, in accordance with ISO 5801 or ISO 13350. Since sound power levels are considered independent of the acoustic environment around the fan, a good comparison can be made between two or more fans proposed for any specific air performance condition. Moreover, these values establish an accurate base for estimating the acoustical outcome of the fan installation in terms of sound pressure levels. A successful estimate of sound pressure levels requires extensive information on the fan and the environment in which it is to be located. It is often advantageous for the equipment user to employ acoustical consultation to ensure that all factors which affect the final sound pressure levels are considered. More detailed information on the complexity of this situation may be found in acoustic textbooks. This document has been developed in response to the need for a reliable and accurate enveloping surface method for determining the sound power levels of fan equipment. Where possible, it has been based on existing National standards and combines state-of-the-art with practical considerations. NOTE The bibliogr
Scope: This document specifies a method to measure sound power by using sound intensity measurements on a measurement surface which encloses the sound source. This document provides guidelines on the acoustical environment, ambient noise, measurement surface, and number of measurements. The installation categories are generally designed to represent the physical orientation of a fan installed in accordance with ISO 5801, ISO 13350 and also defined in ISO 13349-1. This document is applicable to fans defined in ISO 5801 and ISO 13349-1. This document is limited to the determination of airborne sound emission for the specified installation categories. Vibration is not measured, nor is the sensitivity of airborne sound emission to vibration effects determined. The sizes of the fan, which can be tested in accordance with this document are limited only by the practical aspects of the test installations.