ISO 13379-2-2015 PDF

ISO 13379-2-2015 PDF

Condition monitoring and diagnostics of machines - Data interpretation and diagnostics techniques - Part 2: Data-driven applications

$48.00 $96.00 -50%
Product Code: ISO 13379-2
Stock In Stock
Edition: 1ST
Published: 04/01/2015
Number of Pages: 20
File Size: 1 file, 920 Bytes

Available Options

Product Description

Condition monitoring and diagnostics of machines - Data interpretation and diagnostics techniques - Part 2: Data-driven applications

Introduction: This part of ISO 13379 contains general procedures that can be used to determine the condition of a machine relative to a set of baseline parameters. Changes from the baseline values and comparison to alarm criteria are used to indicate anomalous behaviour and to generate alarms: this is usually designated as condition monitoring. Additionally, procedures that identify the cause(s) of the anomalous behaviour are given in order to assist in the determination of the proper corrective action: this is usually designated as diagnostics. © ISO 2015 – All rights reserved

Scope: This part of ISO 13379 gives procedures to implement data-driven monitoring and diagnostic methods to facilitate the work of analysis carried out by specialist staff typically located in a monitoring centre. Although some of the steps are embedded in existing tools, it is essential to be aware of the following steps for optimum use: — selection of the asset, the critical failures and the available process parameters; — data cleaning and resampling; — model development; — model initialization and tuning; — model performance evaluation; — diagnostics process. The implementation of these steps does not require a thorough knowledge of the statistical methods. It does require the competence first to build the training models and then to carry out monitoring and diagnostics processes. The training in data-driven monitoring is carried out on equipment that is exhibiting normal behaviour. In that case, the principle of fault detection is to compare observed data to estimated data. A difference (called residuals) between an observed and expected values of the parameters reveals the presence of an anomaly, which can be related either to equipment or instrument. The training in data-driven diagnosis is carried out both on equipment that is exhibiting normal behaviour and failures. The principle of the method is not to detect the deviation of a parameter but to identify a fault by comparison of the observed situation to the faults learnt during the training phase. The technique usually applied is pattern recognition followed by pattern classification. Data can be available from the data historian of the distributed control system (DCS) or from specialized monitoring systems.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13379-2-2015 PDF

ISO 13379-2-2015 PDF

$48.00 $96.00