ISO 13400-4-2016 PDF

ISO 13400-4-2016 PDF

Road vehicles Diagnostic communication over Internet Protocol (DoIP) - Part 4: Ethernet-based high-speed data link connector

$48.00 $96.00 -50%
Product Code: ISO 13400-4
Stock In Stock
Edition: 1ST
Published: 03/15/2016
Number of Pages: 18
File Size: 1 file, 660 Bytes

Available Options

Product Description

Road vehicles Diagnostic communication over Internet Protocol (DoIP) - Part 4: Ethernet-based high-speed data link connector

Introduction: Vehicle diagnostic communication has been developed, starting with the introduction of the first legislated emission-related diagnostics and has evolved over the years, now covering various use cases ranging from emission-related diagnostics to vehicle manufacturer specific applications like calibration or electronic component software updates. With the introduction of new in-vehicle network communication technologies, the interface between the vehicle’s electronic control units and the external test equipment has been adapted several times to address the specific characteristics of each new network communication technology requiring optimized data link layer definitions and transport protocol developments in order to make the new in- vehicle networks usable for diagnostic communication. With increasing memory size of electronic control units and the demand to update this increasing amount of software and an increasing number of functions provided by these control units, technology of the connecting network and buses has been driven to a level of complexity and speed similar to computer networks. New applications (x-by-wire, infotainment) require high band-width and real time networks (like FlexRay, MOST), which cannot be adapted anymore to be the direct interface to a vehicle. This requires gateways to route and convert messages between the in-vehicle networks and the vehicle interface to external test equipment. The intent of the ISO 13400 series is to describe a standardiz

Scope: This part of ISO 13400 specifies a minimum set of diagnostic Ethernet connector requirements which are based on ISO 15031-3. The ISO 15031-3 diagnostic connector is referenced by legislation in many countries. The diagnostic connection specified in this part of ISO 13400 consists of two mating connectors: the vehicle connector and the external test equipment connector as specified in ISO 15031-3. This part of ISO 13400 specifies: — the functional requirements for the vehicle connector. These functional requirements are separated into two principal areas: connector contact allocation and electrical requirements for connector and related electrical circuits; — the functional requirements for the external test equipment connector. These functional requirements are separated into two principal areas: connector contact allocation and electrical requirements for connector and related electrical circuits. Two (2) different connector layouts and pin-outs are specified in this part of ISO 13400: a) Ethernet pin assignment option 1 (see Annex A); b) Ethernet pin assignment option 2 (see Annex B). Historically, option 1 is specified to meet Ethernet pin assignment of road vehicles already launched onto the market and may be used to resolve conflicts with vehicle manufacturer-specific usage of discretionary pins, e.g. pins 1 and 9. Option 2 is specified to meet the Ethernet pin assignment of road vehicles to resolve conflicts with vehicle manufacturer-specific usage of discretionary pins, e.g. pins 3 and 11. A discovery/identification and activation method of the vehicle’s Ethernet via the “Ethernet Activation Line” is specified in ISO 13400-3.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13400-4-2016 PDF

ISO 13400-4-2016 PDF

$48.00 $96.00