Traitement aseptique des produits de santé - Partie 1: Exigences générales
Introduction: Wherever possible, health care products intended to be sterile should be terminally sterilized in their final sealed container by a terminal sterilization process, which has been validated to achieve a specified sterility assurance level (SAL). ISO/TC 198 has developed standards for terminal sterilization of health care products, for example (but not restricted to): the ISO 11137 series (radiation sterilization), ISO 17665-1 (moist heat sterilization), ISO 20857 (dry heat sterilization), ISO 11135 (ethylene oxide sterilization) and ISO 14160 (liquid chemical sterilization). Where a health care product is intended to be sterile and cannot withstand terminal sterilization in its final container, aseptic processing provides an acceptable alternative for product manufacture. ISO/TC 198 also developed ISO/TS 19930, which provides guidance on aspects of a risk-based approach to assuring sterility of terminally sterilized, single-use health care product that is unable to withstand processing to achieve maximally a 10−6 SAL. Aseptic processing produces a sterile product in its final container by the assembly of component parts (e.g. product, container and container closure) that have been sterilized separately by validated and controlled processes suitable for each component part. Each of these assembly processes can introduce error that can result in product contamination. Furthermore, contamination can be introduced from the personnel, equipment or environment when the sterilized c
Scope: This document specifies the general requirements for, and offers guidance on, processes, programs and procedures for development, validation and routine control of aseptic processing of health care products. This document includes requirements and guidance relative to the overall topic of aseptic processing. Specific requirements and guidance on various specialized processes and methods related to sterilizing filtration, lyophilization, clean-in place (CIP) technologies, sterilization in place (SIP) and isolator systems are given in the other parts of the ISO 13408 series.