ISO 13472-1-2022 PDF

ISO 13472-1-2022 PDF

Acoustics-Measurement of sound absorption properties of road surfaces in situ-Part 1: Extended surface method

$60.00 $120.00 -50%
Product Code: ISO 13472-1
Stock In Stock
Edition: 2ND
Published: 01/2022
Number of Pages: 36
File Size: 1 file, 1 Byte

Available Options

Product Description

Acoustique - Mesurage in situ des propriétés d'absorption acoustique des revêtements de chaussées - Partie 1: Méthode de la surface étendue

Introduction: This document describes a test method for measuring, in situ, the sound absorption coefficient of road surfaces as a function of frequency under normal incidence. This method provides a means of evaluating the sound absorption characteristics of a road surface without damaging the surface. It is intended to be used during road construction, road maintenance and other traffic noise studies. It may also be used to qualify the absorption characteristics of road surfaces used for vehicle and tyre testing. However, the standard uncertainty is limited to 0,05. This method is based on free-field propagation of the test signal from the source to the road surface and back to the receiver, and covers an area of approximately 3 m2 and a frequency range, in one-third- octave bands, from 250 Hz to 4 kHz (see IEC 61260). To complement this method, a spot method (see ISO 13472-2) is available. This method is based on the transmission of the test signal from the source to the road surface and back to the receiver inside a tube and covers an area of approximately 0,1 m2 and a frequency range, in one-third-octave bands, from 315 Hz to 2 kHz. Both methods should give the same results in the frequency range from 315 Hz to 2 kHz. They are both applicable also to acoustic materials other than road surfaces. The measurement results of this method are comparable with the results of impedance tube methods, performed on bore cores taken from the surface (e.g. ISO 10534-1 and ISO 10534-2). The measurem

Scope: This document describes a test method for measuring in situ the sound absorption coefficient of road surfaces as a function of frequency in the range from 250 Hz to 4 kHz. Normal incidence is assumed. However, the test method can be applied at oblique incidence although with some limitations (see Annex F). The test method is intended for the following applications: — determination of the sound absorption properties of road surfaces in actual use; — comparison of sound absorption design specifications of road surfaces with actual performance data of the surface after completion of the construction work. The complex reflection factor can also be determined by this method.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13472-1-2022 PDF

ISO 13472-1-2022 PDF

$60.00 $120.00