ISO 13473-1-2019 PDF

ISO 13473-1-2019 PDF

Characterization of pavement texture by use of surface profiles-Part 1: Determination of mean profile depth

$129.00 $258.00 -50%
Product Code: ISO 13473-1
Stock In Stock
Edition: 2.
Published: 02/2019
Number of Pages: 52
File Size: 1 file, 3.7 MB

Available Options

Product Description

Characterization of pavement texture by use of surface profiles — Part 1: Determination of mean profile depth

Introduction: Road surface texture determines factors such as noise emission from the tyre/pavement interface, acoustic comfort inside vehicles, friction between the tyre and road, rolling resistance and tyre wear. The main concept and the basic terms are illustrated for information in Annex A. Valid methods for measuring surface texture are therefore highly desirable. The so-called “sand patch” method, or the more general “volumetric patch” method (see Clause 3), has been used worldwide for many years to give a single and very simple measurement describing surface texture. It relies on a given volume of sand or glass beads which is spread out on a surface. The material is distributed to form a circular patch, the diameter of which is measured. By dividing the volume of material spread out by the area covered, a value is obtained which represents the average depth of the sand or glass bead layer, known as “mean texture depth” (MTD). The method was originally standardized in ISO 10844:19941), Annex A[5] in order to put limits concerning surface texture for a reference surface used for vehicle noise testing but was later adopted by CEN as EN 13036-1[13]. The volumetric patch method is operator-dependent and can be used only on surfaces which are partly or fully closed to traffic. Therefore, it is not practical for use in network surveys of roads, for example. Along with developments in contactless surface profiling techniques, it has become possible to replace the volumetric patch measuremen

Scope: This document describes a test method to determine the average depth of pavement surface macrotexture (see Clause 3) by measuring the profile of a surface and calculating the texture depth from this profile. The technique is designed to provide an average depth value of only the pavement macrotexture and is considered insensitive to pavement microtexture and unevenness characteristics. The objective of this document is to make available an internationally accepted procedure for determination of pavement surface texture depth which is an alternative to the traditionally used volumetric patch technique (generally using sand or glass beads), giving comparable texture depth values. To this end, this document describes filtering procedures that are designed to give the best possible representation of texture depths determined with the volumetric patch method[13]. Modern profilometers in use are almost entirely of the contactless type (e.g. laser, light slit or light sheet, to mention a few) and this document is primarily intended for this type. However, this does not exclude application of parts of it for other types of profilometers. This ISO 13473 series has been prepared as a result of a need identified when specifying a test surface for vehicle noise measurement (see ISO 10844:2014[6]). Macrotexture depth measurements according to this document are not generally adequate for specifying test conditions of vehicle or traffic noise measurements, but have limited applications as a supplement in conjunction with other ways of specifying a surfacing. This test method is suitable for determining the mean profile depth (MPD) of a pavement surface. This MPD can be transformed to a quantity which estimates the macrotexture depth according to the volumetric patch method. It is applicable to field tests as well as laboratory tests on pavement samples. When used in conjunction with other physical tests, the macrotexture depth values derived from this test method are applicable to estimation of pavement skid resistance characteristics (see e.g. Reference [15]), estimation of noise characteristics and assessment of the suitability of paving materials or pavement finishing techn

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13473-1-2019 PDF

ISO 13473-1-2019 PDF

$129.00 $258.00