Petroleum and natural gas industries — Procedures for testing casing and tubing connections
Introduction: This document is part of a process to provide reliable tubing and casing connections for the oil and natural gas industry which are fit for purpose. It has been developed based on improvements to ISO 13679:2002 and proprietary test procedures, with input from leading users, manufacturers and testing consultants from around the world. This document represents the knowledge of many years of testing and qualification experiences, where many oil and gas industry manufacturers and operators have utilized the testing protocol to improve connection performance with objective evidence, i.e. physical testing. The experimental validation of connection test load envelope and failure limit loads is relevant to design of tubing and casing for the oil and natural gas industries. Tubing and casing are subject to loads which include internal pressure, external pressure, axial tension, axial compression, bending torsion, transverse forces and temperature changes. The magnitude and combination of these loads result in various pipe body and connection failure modes. Although pipe body test and limit loads are well understood in general, the same cannot be stated for the connection. These failure modes and loads are generally different and often less than that of the pipe. Consequently, experimental validation is needed. The validation of test and limit loads implies the testing of performance parameters to these defined loads at the extremes. Testing at the extremes of the performance parameter
Scope: This document specifies tests to perform in order to determine the galling tendency, sealing performance and structural integrity of casing and tubing connections. “Casing” and “tubing” apply to the service application and not to the diameter of the pipe. This document covers the testing of connections for the most commonly encountered well conditions. Not all possible service scenarios are included. For example, the presence of a corrosive fluid, which can influence the service performance of a connection, is not considered. This document supplements API RP 5C5:2017, the requirements of which are applicable with the exceptions specified in this document.