ISO 13696-2022 PDF

ISO 13696-2022 PDF

Optics and photonics-Test method for total scattering by optical components

$60.00 $120.00 -50%
Product Code: ISO 13696
Stock In Stock
Edition: 2ND
Published: 06/2022
Number of Pages: 38
File Size: 1 file, 1 Byte

Available Options

Product Description

Optique et instruments d'optique - Méthodes d'essai du rayonnement diffusé par les composants optiques

Introduction: In most applications, scattering in optical components reduces the efficiency and deteriorates the image-forming quality of optical systems. Scattering is predominantly produced by imperfections of the coatings and the optical surfaces of the components. Common surface features, which contribute to optical scattering, are imperfections of substrates, thin films and interfaces, surface and interface roughness, or contamination and scratches. These imperfections deflect a fraction of the incident radiation from the specular path. The spatial distribution of this scattered radiation is dependent on the wavelength of the incident radiation and on the individual optical properties of the component. For most applications in laser technology and optics, the amount of total loss produced by scattering is a useful quality criterion of an optical component. This document describes a testing procedure for the corresponding quantity, the total scattering value, which is defined by the measured values of backward scattering or forward scattering. The measurement principle described in this document is based on an Ulbricht sphere as the integrating element for scattered radiation. An alternative apparatus with a Coblentz hemisphere, which is also frequently used for collecting scattered light, is described in Annex A.  © ISO 2022 – All rights reserved

Scope: This document specifies procedures for the determination of the total scattering by coated and uncoated optical surfaces. Procedures are given for measuring the contributions of the forward scattering or backward scattering to the total scattering of an optical component. This document applies to coated and uncoated optical components with optical surfaces that have a radius of curvature of more than 10 m. Measurement wavelengths covered by this document range from the ultraviolet above 250 nm to the infrared spectral region below 15 µm. For measurements in the deep ultraviolet between 190 nm to 250 nm, specific methods are considered and are described. Generally, optical scattering is considered as neglectable for wavelengths above 15 µm.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13696-2022 PDF

ISO 13696-2022 PDF

$60.00 $120.00