Water quality - Requirements for establishing performance characteristics of quantitative microbiological methods
Introduction: Methods are considered microbiological when the quantitative estimate is based on counting of microbial particles either directly with the aid of a microscope or indirectly on the basis of growth (multiplication) into colonies, turbidity, a colour change or fluorescence. The principles and procedures within the scope of this document are commonly known as microscopic count, most probable number (MPN) and colony count. Most of the procedures for the determination of performance characteristics described in this document are applicable to all three types of method. However, where the procedures are not applicable, alternative suggestions are made within the body of the document or in Annexes D and E (for repeatability, reproducibility and uncertainty of counting). Plaque counts of bacteriophages are in most respects similar to bacterial colony counts. Some of the ”newer” microbiological methods such as those utilizing fluorescent in situ hybridization (FISH) or polymerase chain reaction (PCR) can also be covered by this document. However, they may require special consideration, depending upon how they are used. The issues of importance in these situations include the mechanism of determining the numbers of microbes present (e.g. standard curve for qPCR or microscopic count for FISH) and the viability of the organisms detected. If such techniques are used for confirmation as part of a method then all sections of this document are relevant. While not essential, during the charact
Scope: This document deals with characterization of microbiological methods. In terms of this document, characterization means the study of parameters that can be measured to describe how the method is likely to perform in a given set of conditions, which can be described as performance characteristics. The document describes procedures for the determination of performance characteristics which can be used for subsequent validation or verification of methods. The emphasis is on selective quantitative methods and this document applies to all types of water. For methods that are not based upon direct microscopic count, colony count or most probable number, the applicability of the procedures described in this document should be considered carefully.