Safety of machinery — Two-hand control devices — Principles for design and selection
Introduction: The structure of safety standards in the field of machinery is as follows: a) type-A standards (basic safety standards) giving basic concepts, principles for design and general aspects that can be applied to all machinery; b) type-B standards (generic safety standards) dealing with one safety aspect or one or more type(s) of safeguard that can be used across a wide range of machinery: — type-B1 standards on particular safety aspects (e.g. safety distances, surface temperature, noise); — type-B2 standards on safeguards (e.g. two-hand controls, interlocking devices, pressure sensitive devices, guards); c) type-C standards (machine safety standards) dealing with detailed safety requirements for a particular machine or group of machines. This document is a type-B2 standard as stated in ISO 12100. This document is of relevance, in particular, for the following stakeholder groups representing the market players with regard to machinery safety: — machine manufacturers (small, medium and large enterprises); — health and safety bodies (regulators, accident prevention organizations, market surveillance etc.). Others can be affected by the level of machinery safety achieved with the means of the document by the above-mentioned stakeholder groups: — machine users/employers (small, medium and large enterprises); — machine users/employees (e.g. trade unions, organizations for people with special needs); — service providers, e.g. for maintenance (small, medium and large enterprises); — cons
Scope: This document specifies the safety requirements of a two-hand control device (THCD) and the dependency of the output signal from the actuation by hand of the control actuating devices. This document describes the main characteristics of THCDs for the achievement of safety and sets out combinations of functional characteristics for three types. It does not apply to devices intended to be used as enabling devices, as hold-to-run devices or as special control devices. This document does not specify with which machines THCDs shall be used. It also does not specify which types of two-hand-control device shall be used for a specific application. Moreover, while guidance is given, it does not specify the required distance between the THCD and the danger zone (see 8.8). This document provides requirements for design and guidance on the selection (based on a risk assessment) of THCDs including the prevention of defeat, the avoidance of faults and verification of compliance. NOTE 1 A THCD only offers protection for the person using it. NOTE 2 For specific machines, the suitability of a two-hand control as a suitable protective device can be defined in a type-C standard. If such a standard does not exist or is not appropriate, the risk assessment and determination of suitable protective measures is the responsibility of the manufacturer of the machine. This document applies to all THCDs, independent of the energy used, including: — THCDs which are fully assembled for installation; — THCDs which are assembled by the machine manufacturer or integrator. This document is not applicable to THCDs manufactured before the date of its publication.