Safety of machinery - Minimum gaps to avoid crushing of parts of the human body
Introduction: The structure of safety standards in the field of machinery is as follows. a) Type-A standards (basis standards) give basic concepts, principles for design and general aspects that can be applied to machinery. b) Type-B standards (generic safety standards) deal with one or more safety aspect(s), or one or more type(s) of safeguards that can be used across a wide range of machinery. — type-B1 standards on particular safety aspects (e.g. safety distances, surface temperature, noise); — type-B2 standards on safeguards (e.g. two-hand controls, interlocking devices, pressure- sensitive devices, guards). c) Type-C standards (machinery safety standards) deal with detailed safety requirements for a particular machine or group of machines. ISO 13854 is a type-B-1 standard as stated in ISO 12100. This document is of relevance, in particular, for the following stakeholder groups representing the market players with regard to machinery safety: — machine manufacturers (small, medium and large enterprises); — health and safety bodies (regulators, accident prevention organizations, market surveillance, etc.). Others can be affected by the level of machinery safety achieved with the means of the document by the abovementioned stakeholder groups: — machine users/employers (small, medium and large enterprises); — machine users/employees (e.g. trade unions, organizations for people with special needs); — service providers, e.g. for maintenance (small, medium and large enterprises); — consumers
Scope: This document enables the user (e.g. standard makers, designers of machinery) to avoid hazards from crushing zones. It specifies minimum gaps relative to parts of the human body and is applicable when adequate safety can be achieved by this method. This document is applicable to risks from crushing hazards only and is not applicable to other possible hazards, e.g. impact, shearing, drawing-in. NOTE For impact, shearing, drawing-in hazards, additional or other measures are to be taken.