Safety of machinery - Prevention of unexpected start-up
Introduction: The structure of safety standards in the field of machinery is as follows: a) type-A standards (basic safety standards) giving basic concepts, principles for design, and general aspects that can be applied to all machinery; b) type-B standards (generic safety standards) dealing with one safety aspect or one or more type(s) of safeguard that can be used across a wide range of machinery: — type-B1 standards on particular safety aspects (e.g. safety distances, surface temperature, noise); — type-B2 standards on safeguards (e.g. two-hand controls, interlocking devices, pressure sensitive devices, guards); c) type-C standards (machine safety standards) dealing with detailed safety requirements for a particular machine or group of machines. This document is a type-B standard as stated in ISO 12100. This document is of relevance, in particular, for the following stakeholder groups representing the market players with regard to machinery safety: — machine manufacturers (small, medium and large enterprises); — health and safety bodies (regulators, accident prevention organizations, market surveillance, etc.) Others can be affected by the level of machinery safety achieved with the means of the document by the above-mentioned stakeholder groups: — machine users/employers (small, medium and large enterprises); — machine users/employees (e.g. trade unions, organizations for people with special needs); — service providers, e.g. for maintenance (small, medium and large enterprises); — cons
Scope: This document specifies requirements for designed-in means aimed at preventing unexpected machine start-up (see 3.2) to allow safe human interventions in danger zones (see Annex A). This document applies to unexpected start-up from all types of energy source, i.e.: — power supply, e.g. electrical, hydraulic, pneumatic; — stored energy due to, e.g. gravity, compressed springs; — external influences, e.g. from wind. This document does not specify performance levels or safety integrity levels for safety-related parts of control systems. While available means to prevent unexpected start-up are identified, this document does not specify the means for the prevention of unexpected machine start-up for specific machines. NOTE A type-C standard can define the required means for the prevention of harm arising from unexpected start-up. Otherwise, the requirements for a specific machine need to be determined by risk assessment outside the scope of this document.