Safety of machinery - Guards - General requirements for the design and construction of fixed and movable guards
Introduction: The structure of safety standards in the field of machinery is as follows: a) type-A standards (basic safety standards) giving basic concepts, principles for design, and general aspects that can be applied to all machinery; b) type-B standards (generic safety standards) dealing with one safety aspect or one or more type(s) of safeguard that can be used across a wide range of machinery: — type-B1 standards on particular safety aspects (e.g. safety distances, surface temperature, noise); — type-B2 standards on safeguards (e.g. two-hand controls, interlocking devices, pressure- sensitive devices, guards); c) type-C standards (machine safety standards) dealing with detailed safety requirements for a particular machine or group of machines. This International Standard is a type-B2 standard as stated in ISO 12100. Guards provide a risk reduction for both protection against unintended access and against ejected parts and substances. The guarding can also give protection against others hazards, e.g. noise, fire, biological hazards, and radiation. The requirements of this document can be supplemented or modified by a type-C standard. For machines that are covered by the scope of a type-C standard and that have been designed and built according to the requirements of that standard, the requirements of that type-C standard take precedence. vi © ISO 2015 – All rights reserved
Scope: This International Standard specifies general requirements for the design, construction, and selection of guards provided to protect persons from mechanical hazards. This International Standard indicates other hazards that can influence the design and construction of guards. This International Standard applies to guards for machinery which will be manufactured after it is published. The requirements are applicable if fixed and movable guards are used. This International Standard does not cover interlocking devices. These are covered in ISO 14119. This International Standard does not provide requirements for special systems relating specifically to mobility such as ROPS (rollover protective structures), FOPS (falling-object protective structures), and TOPS (tip over protective structures) or to the ability of machinery to lift loads.