Bouteilles à gaz - Robinets de bouteilles à gaz - Essais de fabrication et contrôles
Introduction: This document covers the function of a valve as a closure (defined by the UN Model Regulations). Additional features of valves (e.g. pressure regulators, residual pressure-retaining devices, non-return devices and pressure relief devices) might be covered by other standards and/or regulations. Valves conforming to this document can be expected to perform satisfactorily under normal service conditions. This document pays particular attention to manufacturing tests and examinations of valves designed and type tested in accordance with ISO 10297. This document has been written so that it is suitable to be referenced in the UN Model Regulations[1]. In this document, the unit bar is used, due to its universal use in the field of technical gases. It should, however, be noted that bar is not an SI unit, and that the corresponding SI unit for pressure is Pa (1 bar = 105 Pa = 105 N/m2). Pressure values given in this document are given as gauge pressure (pressure exceeding atmospheric pressure) unless noted otherwise. © ISO 2022 – All rights reserved
Scope: This document specifies the procedures and acceptance criteria for manufacturing tests and examinations (sometimes called "initial inspection and tests") of valves designed and type tested in accordance with ISO 10297. This document is applicable to: a) cylinder valves intended to be fitted to refillable transportable gas cylinders; b) main valves (excluding ball valves) for cylinder bundles; c) cylinder valves or main valves with integrated pressure regulator (VIPR); d) valves for pressure drums and tubes. NOTE Where there is no risk of ambiguity, cylinder valves, main valves, VIPR and valves for pressure drums and tubes are addressed with the collective term “valves” within this document. The principles of these manufacturing tests and examinations can be beneficially applied to cylinder valves type tested to national or International Standards other than ISO 10297.