Rubber, vulcanized or thermoplastic - Determination of volume and/or surface resistivity
Introduction: Rubber materials are widely used in many industries, either as the major material or forming a part of the product, because of their unique physical properties which can be tailored by compounding to match the particular requirements of the product specification. Although rubbers are generally regarded as insulating materials, they can be made electrically conductive or dissipative by compounding with a certain amount of carbon black or ionizable ingredients. Hence, the range of electrical resistance to be measured is very wide. It is difficult, however, to obtain high accuracy for measurements in the high- resistance range due to a number of factors. In this document, the guarded-electrode system is used to determine the resistivity of rubber test pieces since it is considered a good compromise between minimizing the errors by shunting away stray currents and using more unwieldy measurement instruments (see also IEC 62631-3-1). ISO 1853, on the other hand, covers rubber materials with medium to low resistance, i.e. resistivities of 108 Ω⋅m or below. It specifies three methods for determining volume resistivity which minimize or eliminate contact resistance. The methods specified in this document were originally designed for the determination of both surface and volume resistivity of insulating rubber materials, but their use can be extended to cover the range from high to low resistivity. It is known that the test results are sensitive to the test conditions, such as tempera
Scope: This document specifies a method for the determination of the volume and the surface resistivity of vulcanized or thermoplastic rubbers. The method can be applied to materials with a resistivity from 101 Ω⋅m to 1017 Ω⋅m.