ISO 14373-2024 PDF

ISO 14373-2024 PDF

Resistance welding-Procedure for spot welding of uncoated and coated low-carbon steels

$60.00 $120.00 -50%
Product Code: ISO 14373
Stock In Stock
Edition: 3.
Published: 01/2024
Number of Pages: 22
File Size: 1 file, 1 Byte

Available Options

Product Description

Soudage par résistance - Mode opératoire pour le soudage par points des aciers à bas carbone revêtus et non revêtus

Introduction: Information on appropriate welding equipment is given in Annex A and information on spot-welding conditions is given in Annex B. This information is provided for guidance only. Depending on the service conditions of the fabrication, the type of welding equipment, the characteristics of the secondary circuit, the electrode force actuation system, the electrode material and the shape, it is possible that certain modifications will be necessary. In such cases, further information can be obtained from the relevant application standard, where one exists. © ISO 2024 – All rights reserved

Scope: This document specifies requirements for resistance spot welding in the fabrication of assemblies of uncoated and metallic-coated or weldable non-metallic-coated low-carbon steel, comprising two or three sheets of metal, where the maximum single-sheet thickness of components to be welded is within the range 0,4 mm to 3,0 mm. This document is applicable to welding of sheets of the same or unequal thickness, where the thickness ratio is less than or equal to 3:1. Welding with the following types of equipment is within the scope of this document: a) pedestal welding equipment; b) portable welding guns; c) automatic welding equipment where the components are fed by robots or automatic feeding equipment; d) multi-spot-welding machines; e) robotic welding machines.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 14373-2024 PDF

ISO 14373-2024 PDF

$60.00 $120.00