ISO 14405-2-2018 PDF

ISO 14405-2-2018 PDF

Geometrical product specifications (GPS) - Dimensional tolerancing - Part 2: Dimensions other than linear or angular sizes

$60.00 $120.00 -50%
Product Code: ISO 14405-2
Stock In Stock
Edition: 2ND
Published: 12/2018
Number of Pages: 30
File Size: 1 file, 1 Byte

Available Options

Product Description

Geometrical product specifications (GPS) — Dimensional tolerancing — Part 2: Dimensions other than linear sizes

Introduction: This document is a geometrical product specification (GPS) standard and is to be regarded as a general GPS standard (see ISO 14638). It influences chain link A of the chain of standards on distance. The ISO GPS Matrix model given in ISO 14638 gives an overview of the ISO GPS system of which this document is a part. The fundamental rules of ISO GPS given in ISO 8015 apply to this document and the default decision rules given in ISO 14253-1 apply to specifications made in accordance with this document, unless otherwise indicated. For dimensions other than linear or angular sizes, the requirement is ambiguous when applied to the real workpiece. It is the presence of form and angular deviations on all real workpieces that makes these requirements ambiguous, i.e. there is a specification ambiguity. This specification ambiguity can only be avoided for features of size toleranced in accordance with ISO 14405-1 or ISO 14405-3. For all other dimensions, geometrical specifications should be used in order to control the specification ambiguity. For more detailed information on the relation of this document to other standards and to the GPS matrix model, see Annex B. © ISO 2018 – All rights reserved

Scope: This document illustrates the ambiguity caused by the use of dimensional specifications to control properties other than linear or angular size and the benefit of using geometrical specifications instead. Dimensional tolerancing can be indicated by ± tolerancing or geometrical specifications. The ambiguity caused by using ± tolerances for dimensions other than linear or angular sizes (for individual tolerances and general tolerances according to, e.g. ISO 2768-1 and ISO 8062-3) is explained in Annex A. NOTE 1 The figures, as shown in this document, merely illustrate the text and are not intended to reflect actual usage. The figures are consequently simplified to indicate only the relevant principles. NOTE 2 For indications of dimensional specifications, see the following: — ISO 14405-1 for linear size; — ISO 14405-3 for angular size; — ISO 2538-1 and ISO 2538-2 for wedges; — ISO 3040 for cones. NOTE 3 The rules for geometrical specifications are given in ISO 1101.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 14405-2-2018 PDF

ISO 14405-2-2018 PDF

$60.00 $120.00