Geometrical product specifications (GPS) - Dimensional tolerancing - Part 3: Angular sizes
Introduction: This part of ISO 14405 is a geometrical product specification (GPS) standard and is to be regarded as a general GPS standard (see ISO 14638). In the general GPS matrix, it influences chain links “Symbols and indications”, “Feature requirements” and “Feature properties” of the size chain of standards. The ISO/GPS Masterplan given in ISO 14638 gives an overview of the ISO/GPS system of which this part of ISO 14405 is a part. The fundamental rules of ISO/GPS given in ISO 8015 apply to this part of ISO 14405 and the default decision rules given in ISO 14253-1 apply to specifications made in accordance with this part of ISO 14405, unless otherwise indicated. For more detailed information on the relation of this part of ISO 14405 to other standards and to the GPS matrix model, see Annex D. © ISO 2016 – All rights reserved
Scope: This part of ISO 14405 establishes the default specification operator for angular size and defines a number of special specification operators for features of angular size: cone (truncated, i.e. frustum, or not), wedge (truncated or not), two opposite straight lines (intersection of a wedge/truncated wedge and a plane perpendicular to the intersection straight line of the two planes of the wedge/truncated wedge, intersection of a cone/frustum and a plane containing the axis of revolution of the cone/frustum). See Figure 1 and Figure 2. This part of ISO 14405 also defines the specification modifiers and the drawing indications for these angular sizes. This part of ISO 14405 covers the following angular sizes: — local angular size: — angular size between two lines; — portion angular size; — global angular size: — direct global angular size: — least squares angular size; — minimax angular size; — rank order angular size/indirect global angular size: — maximum angular size; — minimum angular size; — average angular size; — range of angular sizes; — mid-range angular size; — median angular size; — standard deviation of angular size. This part of ISO 14405 defines the meaning of tolerances of angular sizes indicated as — + and/or - limit deviations, e.g. 0°/-0,5°, or — indicated with upper limit of size (ULS) and/or lower limit of size (LLS), e.g. 35° max. or 15° min., 34°/36°, INTERNATIONAL STANDARD ISO 14405-3:2016(E) © ISO 2016 – All rights reserved ISO 14405-3:2016(E) — with or without modifiers. This part of ISO 14405 provides a set of tools to express several types of angular size characteristics. It does not give any information on the relationship between a function or a use and an angular size characteristic. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 8015, Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules ISO 17450-1, Geometrical product specific