Gears — FZG test procedures — Part 1: FZG test method A/8,3/90 for relative scuffing load-carrying capacity of oils
Introduction: The types of gear failures which can be influenced by the lubricant in use are scuffing, low-speed wear and the gear-surface fatigue phenomena known as micro- and macropitting. In the gear design process, these gear damages are taken into consideration by the use of specific lubricant and service-related characteristic values. For an accurate, field-related selection of these values, adequate lubricant test procedures are required. The FZG2) test procedures described in this document, ISO 14635-2 and ISO 14635-3 can be regarded as tools for the determination of the lubricant-related characteristic values to be introduced into the load-carrying capacity calculation of gears. FZG test method A/8,3/90 for the relative scuffing load-carrying capacity of oils described in this document is typical for the majority of applications in industrial and marine gears. ISO 14635-2 is related to the relative scuffing load-carrying capacity of oils of very high extreme pressure (EP) properties, as used for the lubrication of automotive driveline components. Other FZG test procedures for the determination of low-speed wear, micro- and macropitting load-carrying capacity of gears are intended to be added to the ISO 14635 series as further parts. 2) FZG = Forschungsstelle für Zahnräder und Getriebebau, Technische Universität München (Gear Research Centre, Technical University, Munich). © ISO 2023 – All rights reserved
Scope: This document specifies a test method based on a FZG four-square test machine to determine the relative load-carrying capacity of lubricating oils defined by the gear-surface damage known as scuffing. High surface temperatures due to high surface pressures and sliding velocities can initiate the breakdown of the lubricant films. This test method can be used to assess such lubricant breakdown under defined conditions of temperature, high sliding velocity and stepwise increased load. NOTE This method is technically equivalent to ASTM D 5182-19 and CEC L-07-A-95.