Zinc coatings — Guidelines and recommendations for the protection against corrosion of iron and steel in structures — Part 3: Sherardizing
Introduction: Sherardizing is a thermal diffusion process in which articles are heated in the presence of a sherardizing mixture consisting of zinc dust with or without an inert material. The process is carried out in a slowly rotating closed container at temperatures ranging from about 300 °C to 500 °C. The normal processing temperature is below the melting point of zinc (419 °C). During the process, zinc/iron alloys are built up on the surface of the ferrous articles. A coating thickness of 10 µm to 75 µm (and higher if required) can be achieved. The coating thickness is accurately controlled by the amount of zinc dust, the processing time and temperature. The coating closely follows the contours of the basis material, and uniform coatings are produced on articles, including those of irregular shape. After sherardizing, the containers are cooled down. A screening process separates the sherardized articles from the unused sherardizing mixture. The articles, with the zinc/iron-alloyed layer, are normally post-treated by phosphating, chromating or another suitable passivation process (conversion coating) resulting in a dust-free and clean passivated surface. Most steel and iron articles can be sherardized. © ISO 2017 – All rights reserved
Scope: This document provides guidelines and recommendations regarding the general principles of design that are appropriate for articles to be sherardized for corrosion protection. The protection afforded by the sherardized coating to the article will depend upon the method of application of the coating, the design of the article and the specific environment to which the article is exposed. The sherardized article can be further protected by application of additional coatings (outside the scope of this document), such as organic coatings (wet paints or powder coatings). When applied to sherardized articles, this combination of coatings is often known as a “duplex system”. General guidance on this subject can be found in ISO 12944-5 and EN 13438. The maintenance of corrosion protection in service for steel with sherardized coatings is outside the scope of this document. Specific product-related requirements (e.g. for sherardized coatings on fasteners or tubes, etc.) will take precedence over these general recommendations.