Thermal spraying — Quality requirements for manufacturers of thermal sprayed coatings
Introduction: Thermal spraying processes are widely applied for producing industrial products and are mainly applied for preventive protection of surfaces. The application can take place both within the workshop as well as on site. Measures for the maintenance of worn coatings or of surfaces on components are also in the field of use. Thermal spraying can be found in all industries, but especially in the aerospace, stationary gas turbine, automotive, machinery construction, printing and chemical, and oil extraction and refining fluid control industries, as well as for medical purposes and for steel construction in the field of off-shore and on-shore, etc. Usually coatings are applied for anticorrosive and/or anti-wear purposes, high temperature protection and against chemical attack, as well as for aesthetic or electrical reasons. Thermal spraying belongs to the so-called "special processes", where the quality of the coating cannot be unambiguously determined by testing without damaging the component. For an adequate use of thermal sprayed coatings and in order to avoid quality or cost-intensive problems when manufacturing and during service time, conditions and processes must be controlled. Therefore, a functional quality assurance system is made available for the coating factory, if necessary, in additional to a quality management system (e.g. ISO 9001). This document provides three different levels of quality requirements (comprehensive level C, standard level S and elementary level E).
Scope: This document specifies quality requirements for manufacturers of thermal sprayed coatings to ensure quality assurance for activities in the field of production. NOTE It is independent of the availability of a quality management system, e.g. ISO 9001, ISO 14001 and ISO 45001, which concern the concept and organization of the quality management. This document defines the quality requirements that are of importance for the manufacturing route. This document is applicable to thermal spraying including all the pre- and post-treatments of the whole coating process for new parts, for repairs and maintenance (e.g. after service) at the workshop or on site.