Conteneurs de la série 1 - Spécifications et essais - Partie 4: Conteneurs non pressurisés pour produits solides en vrac
Introduction: This document replaces the first edition published in 1991 and brings it into line with other parts of this document including Part 1 which provides information on those tests that are consistent for all freight containers. Freight containers built to transport non-pressurised bulk cargos are considered to be special and therefore not produced in large numbers, and often, freight containers built to meet the requirements of ISO 1496-1 are used in their place. However, when the bulk cargo is classified as a dangerous cargo as identified in the United Nations' Recommendations on the Transport of Dangerous Goods - Model Regulations,[2] such cargoes must be transported in a bulk container as described in 6.8 of those regulations. A freight container built and tested according to this document are deemed to meet with the requirements for a BK1 or a BK2 bulk container as described in the Recommendations on the transport of Dangerous Goods – Model Regulations.[2] To fully meet these requirements the container will need to be: — rendered siftproof, either by design or by the addition of a siftproof liner, — fitted with suitable securing means for service equipment required for packing and unpacking. Containers to be used for the carriage of dangerous goods can be subject to additional international and national requirements as applied by competent authorities. Freight containers constructed in accordance with ISO 1496-1 may be used for the transport certain non-packed dry bulk solids
Scope: This document specifies the basic specifications and testing requirements for series 1 freight containers of the dry bulk container non-pressurized type which are suitable for international exchange and for conveyance by road, rail and sea, including interchange between these forms of transport. As the density and flow characteristics of dry bulk cargoes vary widely, containers conforming to this document are not expected to be suitable for the carriage of all such cargoes. Therefore, except where otherwise stated, the requirements of this document are minimum requirements. The container types covered by this document are given in Table 1. This document does not apply to BK3 flexible bulk containers.