ISO 15086-2-2025 PDF

ISO 15086-2-2025 PDF

Hydraulic fluid power-Determination of the fluid-borne noise characteristics of components and systems-Part 2: Measurement of the speed of sound in a fluid in a pipe

$142.00 $284.00 -50%
Product Code: ISO 15086-2
Stock In Stock
Edition: 2.
Published: 02/2025
Number of Pages: 32
File Size: 1 file, 2 Bytes

Available Options

Product Description

Transmissions hydrauliques - Évaluation des caractéristiques du bruit liquidien des composants et systèmes - Partie 2: Mesurage de la vitesse du son émis dans un fluide dans une tuyauterie

Introduction: In hydraulic fluid power systems, power is transmitted and controlled through a liquid under pressure within an enclosed circuit. During the process of converting mechanical power into hydraulic fluid power, flow and pressure ripple and structure-borne vibrations are generated. Hydro-acoustical characteristics of hydraulic components can be measured with acceptable accuracy if the speed of sound in the fluid is precisely known. The measurement technique for determining the speed of sound in a pipe, as described in this document, is based upon the application of plane wave transmission line theory to the analysis of pressure ripple in rigid pipes[1]. Two different measurement approaches are presented, namely the use of — three pressure transducers in a pipe, and — acoustic antiresonance in a closed-end pipe system. The three-pressure-transducer method should be used at any time when the speed of sound is to be measured under the effective working conditions in a system. This method can be performed simultaneously with the hydro-acoustical measurement methods specified in ISO 10767-1, ISO 10767-3 and ISO 15086-3, using the same equipment and measurements. Either method is suitable to produce a table of speed-of-sound data as a function of mean pressure and temperature for a particular fluid. © ISO 2025 – All rights reserved

Scope: This document describes the procedure for the determination of the speed of sound in a fluid enclosed in a pipe, by measurements from pressure transducers mounted in the pipe. This document is applicable to all types of hydraulic circuit operating under steady state conditions, irrespective of size, for pressure pulsations over a frequency range from 10 Hz to 3 kHz.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 15086-2-2025 PDF

ISO 15086-2-2025 PDF

$142.00 $284.00