ISO 15106-5-2015 PDF

ISO 15106-5-2015 PDF

Plastics - Film and sheeting - Determination of water vapour transmission rate - Part 5: Pressure sensor method

$48.00 $96.00 -50%
Product Code: ISO 15106-5
Stock In Stock
Edition: 1ST
Published: 04/15/2015
Number of Pages: 12
File Size: 1 file, 278 Bytes

Available Options

Product Description

Plastics - Film and sheeting - Determination of water vapour transmission rate - Part 5: Pressure sensor method

Scope: This part of ISO 15106 specifies a method for determining the water vapour transmission rate of plastic film, plastic sheeting, and multi-layer structures including plastics, using a pressure sensor. NOTE The method provides rapid measurement over a wide range of water vapour transmission rates. 2 Terms and definitions For the purposes of this document, the following terms and definitions apply. 2.1 water vapour transmission rate amount of water vapour transmitted through unit area of test specimen per unit time under specified conditions Note 1 to entry: Water vapour transmission rate is expressed in grams per square metre per 24 h [g/(m2 · 24 h)]. 3 Principle A test specimen is mounted in a transmission cell (see Figure 1) forming a sealed barrier between two chambers. The upstream chamber is usually the high-pressure side and the downstream chamber is usually the low-pressure side. The downstream chamber and the upstream chamber are evacuated after introducing the test specimen into the transmission cell. After the evacuation, water vapour is introduced into the upstream chamber. The water vapour permeates from the upstream chamber to the downstream chamber. The amount of water vapour which permeates through the test specimen is determined by the increase of the pressure in the downstream chamber. 4 Test specimens 4.1 The specimens shall be representative of the material, free from wrinkles, creases and pinholes, and have uniform thickness. Each specimen shall have a larger area than the transmission area of the cell. NOTE Uneven final products are not suitable for the specimens to avoid water vapour leakage. 4.2 Three specimens shall be tested unless otherwise specified or agreed between the interested parties. 5 Conditioning The specimens shall be conditioned at the same temperature and humidity as specified for the test for a length of time appropriate to the material under test, unless otherwise agreed between the interested parties. INTERNATIONAL STANDARD ISO 15106-5:2015(E) © ISO 2015 – All rights reserved

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 15106-5-2015 PDF

ISO 15106-5-2015 PDF

$48.00 $96.00