ISO 15118-10-2025 PDF

ISO 15118-10-2025 PDF

Road vehicles-Vehicle to grid communication interface-Part 10: Physical layer and data link layer requirements for single-pair Ethernet

$71.50 $143.00 -50%
Product Code: ISO 15118-10
Stock In Stock
Edition: 1.
Published: 03/2025
Number of Pages: 22
File Size: 1 file, 1 Byte

Available Options

Product Description

Road vehicles — Vehicle to grid communication interface — Part 10: Physical layer and data link layer requirements for single-pair Ethernet

Introduction: The looming energy crisis and necessity to reduce greenhouse gas emissions has forced vehicle manufacturers to find ways to scale down how much energy their vehicles consume. The vehicles they are currently developing are propelled either entirely or in part by electric energy. If this energy is generated from renewable sources, this will weaken dependency on oil, improve the global energy efficiency and cut CO2 emissions. However, a dedicated charging infrastructure is needed to charge the batteries that power these vehicles. Much of the standardization work on dimensional and electrical specifications of the charging infrastructure and the vehicle interface is already treated in the relevant ISO or IEC groups. However, the question of information transfer between the electric vehicles (EV) and electric vehicle supply equipment (EVSE) has not been treated sufficiently. This communication is key to optimizing energy resources and energy production systems so vehicles can be charged cheaply and efficiently. In this document, messages are exchanged between the vehicle and the infrastructure over single-pair Ethernet (which is embedded in the cable assembly). The relevant information on use-case definitions requirements can be found in ISO 15118-1. Network and application protocol requirements can be found in ISO 15118-20, respectively. © ISO 2025 – All rights reserved

Scope: This document specifies the physical and data link layer of high-level communication (HLC) between electric vehicles (EV) and electric vehicle supply equipment (EVSE) based on single-pair Ethernet communication. Single-pair Ethernet communication uses differential twisted pair wires that are dedicated and balanced. This document applies to 10BASE-T1S only. This document covers the overall information exchange between all actors involved in electrical energy exchange. The ISO 15118 series applies to charging between EV and EVSE.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 15118-10-2025 PDF

ISO 15118-10-2025 PDF

$71.50 $143.00