Plastiques - Méthodes d'exposition aux intempéries marines
Introduction: Plastics are often used in outdoor applications where they are immersed or partially immersed in water. In some cases, materials made from plastic are designed to float on water. In others, plastic articles that are discarded end up as floating debris. In addition to the effects of global solar radiation and heat, plastic polymers or products exposed in marine environments may be subjected to hydrolysis, water absorption, extraction of stabilizers, erosion by wave action, corrosion by salts and/or attack by seaborne microorganisms. These stresses are not simulated in typical weathering exposures conducted in accordance with ISO 877-1, ISO 877-2 and ISO 877-3. Therefore, it is necessary to define procedures that realistically and consistently stress plastic materials in the same way that they would be in products used or discarded in marine environments. This document describes three procedures for the exposure of plastic materials in the same way as they could be when used in marine environments. There are four primary reasons why the rate of degradation of plastics exposed at sea can be different from that for the same plastic exposed on land: a) exposure in moist conditions is known to accelerate degradation of some polymers — small amounts of absorbed water can act as a plasticizer, increasing accessibility of the matrix to oxygen, or can leach out stabilizing additives; b) differences in heat build-up between plastics exposed in water or on the surface compared to plastic
Scope: This document describes three methods for the exposure of plastics in a marine environment. Method A covers exposures where specimens float on the surface, method B covers exposures where specimens are partially immersed method C covers exposures where specimens are completely immersed. Although intended for marine (salt water) exposure, the methodology can be used with outdoor brackish water and fresh-water exposures as well. Direct weathering of plastics on land is described in ISO 877-1, ISO 877-2 and ISO 877-3. Method A is particularly applicable to enhanced-degradability plastics where the environmental degradation under marine floating exposure is expected to be accelerated relative to that of regular plastic materials. This document specifies the general requirements for the apparatus, and procedures for using the test methods described. It lists properties that can be used to evaluate changes in plastics subjected to marine exposure. More specific information about methods for determining the changes in properties of plastics on exposure and reporting these results is given in ISO 4582.