ISO 15363-2017 PDF

ISO 15363-2017 PDF

Metallic materials - Tube ring hydraulic pressure test

$48.00 $96.00 -50%
Product Code: ISO 15363
Stock In Stock
Edition: 2ND
Published: 07/2017
Number of Pages: 14
File Size: 1 file, 332 Bytes

Available Options

Product Description

Metallic materials - Tube ring hydraulic pressure test

Scope: This document specifies the ring hydraulic pressure test for metallic tubes. It is generally applied to tubes with an outside diameter greater than 120 mm and outside diameter to thickness ratio of not less than 20. The objective of this test is to ascertain the value of the hoop stress required to produce a specified total circumferential (hoop) strain. 2 Symbols Symbols and corresponding designations are given in Table 1. Table 1 — Symbols and designations Symbol Designation Unit Measured tube test ring thickness At Specified total circumferential strain Measured outside diameter of the tube test ring Length of tube test ring Hydrostatic pressure to produce the specified total circumferential strain MPa RAt Hoop strength at the specified total strain MPa NOTE For symbols used in standards for steel tubes, please see Annex B. 3 Principle Unrestrained expansion of the test ring between two platens, under internal hydraulic pressure; the outer circumference of the tube is the effective test piece gauge length. The test is carried out on a test piece taken from a welded or seamless tube of thickness up to a limit dependent upon the capacity of the machine and the strength of the tube (see Figure 1). All sharp edges are removed from product machined surfaces before testing. Where the hydraulic pressure required to produce the specified circumferential strain exceeds the capacity of the test machine, modified tests may be carried out as described in Annex A. The test is specified when a measure of the hoop strength is required which is not influenced by cold forming and residual stress introduced when flattening a standard tensile test piece. The standard tensile test is necessary, however, when tensile strength and elongation measurements are required. © ISO 2017 – All rights reserved

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 15363-2017 PDF

ISO 15363-2017 PDF

$48.00 $96.00