Principles for selecting and using test persons for testing anthropometric aspects of industrial products and designs
Introduction: An investigation into how far ergonomic requirements are taken into consideration with regard to industrial products and designs is often performed using test equipment that permits only one or a few parameters (e.g. body height) to be registered. With regard to the concurrent multifunctional testing and/or determination of product characteristics for which no technical testing procedures have been established, one or more people are often designated as test persons and are observed and/or questioned during or after product testing. The reliability of any findings established in this way is very much dependent on the extent to which the test persons represent the intended user group in different aspects. How well a product or design is adjusted to the anthropometrics of the intended user population is dealt with in this document. According to ISO 14738, workstations at machinery has to be designed with proper regard to the body dimensions of the intended user population. One means to verify that a product or a design fulfils this requirement is to set up a panel of test persons and let them test the product in different ways. An example of the use of this document is given in Annex A. © ISO 2022 – All rights reserved
Scope: This document establishes methods for determining the composition of groups of persons whose anthropometric characteristics are to be representative of the intended user population of any specific object under test. This document is applicable to the testing of anthropometric aspects of industrial products and designs having direct contact with the human body or dependent on human body measurements, such as machinery, work equipment, personal protective equipment (PPE), consumer goods, working spaces, architectural details or transportation equipment. This document is also applicable to the testing of such safety aspects of products that are dependent on human body measurements. It does not deal with other aspects of the task or other requirements, such as perception of information (except geometrical arrangement of the viewing targets) and the use of controls (except their geometrical placement). Although this document deals with selecting test persons from an anthropometric perspective, similar general principles can be applied for other test variables, e.g. biomechanical aspects.