Silk - Electronic test method for defects and evenness of raw silk
Introduction: Seriplane test is currently used to test defects and evenness of raw silk. The test is carried out in an inspection room with a special lighting system. Due to the difference of the coverage area of the threads on the board, and the penetration and reflection of the light, the evenness or stripes, cleanness, and neatness can be visually judged by comparing the Seriplane boards with the standard photos. The capacitive tester for raw silk detects the electrical capacitance variation correlated with the mass variation of the silk thread when running through the sensor split having a certain length. The dimension and classification of defects are defined by setting the parameters of mass variation. The optical tester detects the photometric variation of the shadow of silk thread correlated with the cross sectional area variation of the thread. The dimension and classification of defects are defined by setting the parameters of cross sectional area variation. The optical tester can detect the shape of defects that cannot be done by capacitive tester, but the later tester can detect the evenness of the raw silk precisely, thus the two kinds of tests give to some extent parallel information (defects are detected and counted with both sensors) but give also complementary information not available with a single sensor alone. © ISO 2014 – All rights reserved
Scope: This International Standard specifies a test method for defects and evenness of raw silk by capacitive and optical electronic testers. This International Standard is applicable to raw silk with the yarn size between 13,3 dtex and 76,7 dtex or 12 denier and 69 denier, whether in skein or on cone, soaked or unsoaked.