ISO 16000-3-2026 PDF

ISO 16000-3-2026 PDF

Indoor air-Part 3: Determination of formaldehyde and other carbonyl compounds in indoor air and test chamber air-Active sampling method

$60.00 $120.00 -50%
Product Code: ISO 16000-3
Stock In Stock
Edition: 4.
Published: 09/2026
Number of Pages: 38
File Size: 1 file, 1.2 MB

Available Options

Product Description

Air intérieur - Partie 3: Dosage du formaldéhyde et d'autres composés carbonylés dans l'air intérieur et dans l'air des chambres d'essai - Méthode par échantillonnage actif

Introduction: This document is intended to be used for characterizing indoor air following the sampling strategy specified in ISO 16000-2 [1]. This document applies to 14 aldehydes and ketones. Formaldehyde is the simplest carbonyl compound, with one carbon, one oxygen and two hydrogen atoms. In its monomolecular state, formaldehyde is a colourless, pungent and reactive gas. Formaldehyde has been used in the production of urea-formaldehyde resins, adhesives and insulating foams. Emissions from particle (chip) board and wall insulation are the major sources of formaldehyde in indoor air. As formaldehyde has a high toxic potential, [2] determining its level accurately is key for air quality. When formaldehyde is collected by passing air through a reactive medium that converts the compound to a derivative of lower vapour pressure is more efficiently retained by the sampler and its level can be easily analysed. ISO 16017-1 [3], ISO 16017-2 [4], ISO 12219-1 [5] and ISO 12219-5 [6] describe analytical methods for a broader spectrum of volatile organic compounds (VOCs) and can be used if other groups besides carbonyl compounds are to be analyzed. Instead of systematic International Union of Pure and Applied Chemistry (IUPAC) nomenclature, traditional names are used in this document. Some equivalent names are: — acetaldehyde for ethanal; — acetone for 2-propanone; — butyraldehyde for butanal; — capronaldehyde for hexanal; — formaldehyde for methanal; — isovaleraldehyde for 3-methylbutanal; — propi

Scope: WARNING — Persons using this document should be familiar with normal laboratory practice. This document does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user to establish appropriate safety and health practices and to ensure compliance with any national regulatory conditions. This document specifies a sampling method to determine the quantity of formaldehyde (HCHO) in the air with the range of approximately 1 µg/m3 to 1 mg/m3 in a time-weighted average (TWA) sample, for long-term (1 h to 24 h) and short-term (5 min to 60 min) sampling. This method involves the collection of compounds from air on to adsorbent cartridges coated with 2,4-dinitrophenylhydrazine (DNPH) and subsequent analysis of the hydrazones formed by high performance liquid chromatography (HPLC) with detection by ultraviolet absorption [7][8]. This document can also be applied for the determination of at least 12 other aromatic as well as saturated and unsaturated aliphatic carbonyl compounds (aldehydes and ketones), with modification, such as: — acetaldehyde; — acetone; — benzaldehyde; — butyraldehyde; — capronaldehyde; — 2,5-dimethylbenzaldehyde; — formaldehyde; — isovaleraldehyde; — propionaldehyde; — m-tolualdehyde; — o-tolualdehyde; — p-tolualdehyde; — valeraldehyde. This document does not apply to longer chained or unsaturated carbonyl compounds such as acrolein. An alternative sampling method using sorbent tubes and analysis by thermal desorption using gas chromatography with mass spectrometry (GC-MS) is given in Annex A. © ISO 2026 – All rights reserved ISO 16000-3:2026(en) 2 Normative references There are no normative references in this document. 3 Terms and definitions No terms and definitions are listed in this document. ISO and IEC maintain terminology databases for use in standardization at the following addresses: — ISO Online browsing platform: available at https://​www​.iso​.org/​obp — IEC Electropedia: available at https://​www​.electropedia​.org/​ 4 Principle The method specified in this document involves the collection of compounds from air on to adsorbent cartridges containing silica gel coated with 2,4-DNP

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16000-3-2026 PDF

ISO 16000-3-2026 PDF

$60.00 $120.00