Indoor air - Part 37: Measurement of PM2,5 mass concentration
Introduction: Airborne particulate matter (colloquially known as “fine dust”) plays a role not only outdoors, but is also significant in terms of hygiene, especially indoors. People in industrialized countries spend most of the day indoors. Either particles are transported into indoor air from outdoor environments or the particles directly result from indoor sources, such as smoking, residential wood burning and cooking. PM2,5 concentration and composition in indoor environments strongly depend on parameters such as the room size, relative humidity, air exchange rate, airflow conditions and sink effects on surfaces (e.g. walls, ceilings, floor coverings, furnishings). In addition, particles already sedimented are temporarily resuspended to the air through various activities and can be inhaled. All this can result in highly variable levels of indoor PM2,5 pollution that are not easily ascertained or assessed in terms of their impacts on health. This document describes the general strategies for the measurement of indoor PM2,5 concentration. This document was prepared in response to the need for improved comparability of methods for particle measurement. © ISO 2019 – All rights reserved
Scope: This document specifies the measurement methods and strategies for determining the PM2,5 mass concentrations of suspended particulate matter (PM) in indoor air. It can also be used for determining PM10 mass concentration. The reference method principle consists of collecting PM2,5 on a filter after separation of the particles by an impaction head and weighing them by means of a balance. Measurement procedure and main requirements are similar to the conditions specified in EN 12341. This document also specifies procedures for operating appropriate supplementary high time resolution instruments, which can be used to highlight peak emission, room investigation and as part of the quality control of the reference method. Quality assurance, determination of the measurement uncertainty and minimal reporting information are also part of this document. The lower range of application of this document is 2 µg/m3 of PM2,5 (i.e. the limit of detection of the standard measurement method expressed as its uncertainty). This document does not cover the determination of bioaerosols or the chemical characterization of particles. For the measurement and assessment of dust composition, see the relevant technical rules in the International Standards in the ISO 16000 series. This document does not cover passenger compartments of vehicles and public transport systems.