ISO 16000-9-2024 PDF

ISO 16000-9-2024 PDF

Indoor air-Part 9: Determination of the emission of volatile organic compounds from samples of building products and furnishing-Emission test chamber method

$60.00 $120.00 -50%
Product Code: ISO 16000-9
Stock In Stock
Edition: 2.
Published: 03/2024
Number of Pages: 24
File Size: 1 file, 1 Byte

Available Options

Product Description

Air intérieur - Partie 9: Dosage de l'émission de composés organiques volatils de produits de construction et d'objets d'équipement - Méthode de la chambre d'essai d'émission

Introduction: The objectives of the determination of volatile organic compounds (VOCs) emitted from building products using emission test chambers in conjunction with the standardised sampling, storage of samples and preparation of test specimens are: — to provide manufacturers, builders and end users with emission data useful for the evaluation of the impact of building products on the indoor air quality; — to promote the development of improved products. The method can in principle be used for most building products used indoors. Sampling, transport and storage of materials to be tested, and preparation of test specimens are described in ISO 16000-11. Air sampling and analytical methods for the determination of VOCs are specified in ISO 16000-6 and ISO 16017-1. A general description of an emission test chamber is given in Annex C. For the determination of formaldehyde emissions from wood-based panels, refer to EN 717-1[1]. The measurement procedure for formaldehyde is described in ISO 16000-3[2]. The determination of the emission rates of cut edges is described in Annex D. © ISO 2024 – All rights reserved

Scope: This document specifies a general laboratory test method for the determination of the area specific emission rate of volatile organic compounds (VOCs) from samples of newly produced building products or furnishing under defined climate conditions. The method can also, in principle, be applied to samples of aged products. The emission data obtained can be used to calculate concentrations in a model room (see Table B.1). This document is applicable to various emission test chambers used for the determination of the emission of VOCs from building products or furnishing. This document is also applicable to samples of wood-based panels and other building products, in order to determine the emission rate of formaldehyde. NOTE In principle, this document can be applied to the study of any gas phase emissions from samples of building products and furnishing.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16000-9-2024 PDF

ISO 16000-9-2024 PDF

$60.00 $120.00