Methods for the calibration of vibration and shock transducers - Part 43: Calibration of accelerometers by model-based parameter identification
Introduction: The ISO 16063 series describes in several of its parts (ISO 16063-1, ISO 16063-11, ISO 16063-13, ISO 16063-21 and ISO 16063-22) the devices and procedures to be used for calibration of vibration transducers. The approaches taken can be divided in two classes: one for the use of stationary signals, namely sinusoidal or multi-sinus excitation; and the other for transient signals, namely shock excitation. While the first provides the lowest uncertainties due to intrinsic and periodic repeatability, the second aims at the high intensity range where periodic excitation is usually not feasible due to power constraints of the calibration systems. The results of the first class are given in terms of a complex transfer sensitivity in the frequency domain and are, therefore, not directly applicable to transient time domain application. The results of the second class are given as a single value, the peak ratio, in the time domain that neglects (knowingly) the frequency-dependent dynamic response of the transducer to transient input signals with spectral components in the resonance area of the transducer’s response. As a consequence of this “peak ratio characterization”, the calibration result might exhibit a strong dependence on the shape of the transient input signal applied for the calibration and, therefore, from the calibration device. This has two serious consequences: a) The calibration with shock excitation in accordance with ISO 16063-13 or ISO 16063-22 is of limited use as far
Scope: This document prescribes terms and methods on the estimation of parameters used in mathematical models describing the input/output characteristics of vibration transducers, together with the respective parameter uncertainties. The described methods estimate the parameters on the basis of calibration data collected with standard calibration procedures in accordance with ISO 16063-11, ISO 16063-13, ISO 16063-21 and ISO 16063-22. The specification is provided as an extension of the existing procedures and definitions in those International Standards. The uncertainty estimation described conforms to the methods established by ISO/IEC Guide 98-3 and ISO/IEC Guide 98-3/Supplement 1. The new characterization described in this document is intended to improve the quality of calibrations and measurement applications with broadband/transient input, like shock. It provides the means of a characterization of the vibration transducer’s response to a transient input and, therefore, provides a basis for the accurate measurement of transient vibrational signals with the prediction of an input from an acquired output signal. The calibration data for accelerometers used in the aforementioned field of applications should additionally be evaluated and documented in accordance with the methods described below, in order to provide measurement capabilities and uncertainties beyond the limits drawn by the single value characterization given by ISO 16063-13 and ISO 16063-22.