Machine tools safety — Machining centres, milling machines, transfer machines — Part 1: Safety requirements
Introduction: This document is a type-C standard as stated in ISO 12100. This document is of relevance, in particular for the following stakeholder groups representing the market players with regard to machinery safety: — machine manufacturers (small, medium and large enterprises); — health and safety bodies (regulators, accident prevention organisations, market surveillance, etc.). Others can be affected by the level of machinery safety achieved with the means of the document by the above-mentioned stakeholder groups: — machine users/employers (small, medium and large enterprises); — machine users/employees (e.g. trade unions, organizations for people with special needs); — service providers, e.g. for maintenance (small, medium and large enterprises); — consumers (in case of machinery intended for use by consumers). The above-mentioned stakeholder groups have been given the possibility to participate at the drafting process of this document. The machinery concerned and the extent to which hazards, hazardous situations or hazardous events are covered are indicated in the Scope of this document. When requirements of this type-C standard are different from those stated in type-A or type-B standards, the requirements of this type-C standard take precedence over the requirements of the other standards for machines that have been designed and built according to the requirements of this type-C standard. Machining centres, milling machines and transfer machines present a wide range of hazards. Pr
Scope: This document specifies the technical safety requirements and protective measures for the design, construction and supply (including installation and dismantling, with arrangements for transport and maintenance) of: — milling machines (see 3.1.1), including machines capable of performing boring operations (see 3.1.2); — machining centres; and — transfer machines (see 3.1.3) designed for continuous production use, which are intended to cut cold metal and other non- combustible cold materials, except wood or materials with physical characteristics similar to those of wood as defined in ISO 19085-1 and glass, stone and engineered/agglomerated materials as defined in EN 14618. This document covers the following machines (referred to as "machines" in this document): a) manually, without numerical control, operated boring and milling machines (see 3.2.1, Group 1), e.g. knee and column type milling machines (see Figures C.1 and C.2); b) manually, with limited numerical control, operated boring and milling machines (see 3.2.2, Group 2), e.g. profile and contouring milling machines (see Figures C.3 and C.4); c) numerically controlled milling machines and machining centres (see 3.2.3, Group 3), e.g. automatic milling machines and milling centres, e.g. multi-spindle milling machines, gear-milling machines (see Figures C.5 to C.7); d) transfer and special-purpose machines (see 3.2.4, Group 4), which are designed to process only pre-specified workpieces or limited range of similar workpieces by means of a predetermined sequence of machining operations and process parameters (see Figures C.8 to C.13). e) machines fitted with the following devices/facilities, whose hazards have been dealt with: — tool magazine(s); — tool changer(s); — workpiece handling mechanism(s); — powered workpiece clamping mechanism(s); — swarf/chip conveyor(s); — power-operated door(s); — moveable operator cabin(s); © ISO 2022 – All rights reserved ISO 16090-1:2022(E) — additional equipment for turning; — additional equipment for grinding. This document deals with all significant hazards, hazardous situations and events relevant to this type of machinery which can occur during transportation, assembly a