ISO 16124-2015 PDF

ISO 16124-2015 PDF

Steel wire rod - Dimensions and tolerances

$48.00 $96.00 -50%
Product Code: ISO 16124
Stock In Stock
Edition: 2ND
Published: 03/15/2015
Number of Pages: 16
File Size: 1 file, 325 Bytes

Available Options

Product Description

Steel wire rod - Dimensions and tolerances

Scope: This International Standard specifies dimensions and tolerances to the dimensions applicable to steel wire rod as defined in ISO 6929. 2 Dimensions and tolerances on dimensions The dimensions and tolerances applicable to the dimensions of hot-rolled steel wire rod shall be as specified in 2.1 to 2.4. 2.1 Round wire rod The preferred nominal sizes and tolerances on diameters shall be as specified in Table 1 and Table 2, respectively. Four levels of tolerance are standardized: T1, T2, T3 and T4. The maximum permissible out-of-round for all sizes, measured as the difference between the maximum and the minimum diameter of the same cross-section, shall be 80 % of the total tolerance specified on the diameter (see Table 2). Table 1 — Preferred diameter, nominal section, and nominal mass of round wire rod Preferred diameter, d Cross-sectional areaa mm² Mass per unit lengtha kg/m 19,63 0,154 5,5 23,76 0,187 28,27 0,222 6,5 33,18 0,260 38,48 0,302 7,5 44,18 0,347 50,26 0,395 For information only. NOTE 1 Cross-sectional area: S = 0,7854d² NOTE 2 Mass/m = 0,00785S. INTERNATIONAL STANDARD ISO 16124:2015(E) © ISO 2015 – All rights reserved

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16124-2015 PDF

ISO 16124-2015 PDF

$48.00 $96.00