Acoustics - Laboratory measurement of the reduction of transmitted impact noise by floor coverings on a small floor mock-up - Part 1: Heavyweight compact floor
Introduction: The improvement of impact sound reduction is the main quantity for describing the acoustic behaviour of floor coverings. Its determination is described in the ISO 10140[4]series and requires the use of a special test facility. This facility consists of two rooms (the lower one of at least 50 m3), separated by an approximately 14 cm thick concrete slab or a special timber joist floor. Manufacturers of floor coverings see the advantage of having their own test facilities, but the investment often is not affordable for small- and medium-sized enterprises. This part of ISO 16251 aims to reduce the effort for the determination of the impact sound reduction. A standardized test method is provided, which yields results comparable to those gained with the ISO 10140 series[4]. © ISO 2014 – All rights reserved
Scope: This part of ISO 16251 specifies a laboratory measurement method to determine the improvement of impact sound insulation by a floor covering when laid on a standard concrete floor mock-up and excited by a standard tapping machine. The method is restricted to soft, flexible floor coverings, which transmit impact sound mainly “locally” into the floor, i.e. through the area close to the points of excitation, so that the size of the flooring specimen does not have an influence on the results. Examples of such floor coverings are carpets, PVC, and linoleum. These floor coverings correspond to ISO 10140-1:2010[5], Annex H, category I. The results only provide information about the noise radiated. A subjective classification of the quality of the floor coverings is not intended. The method is kept as close as possible to the ISO 10140[4] series and yields the same results within the range of uncertainty and within the range of application. In the case of difference with ISO 10140, the result of the ISO 10140 measurement shall be used. This part of ISO 16251 provides the measurement method. Product test codes can contain further requirements concerning the specimens, such as temperature range, the number of test specimens or special mounting conditions. NOTE If non-soft, non-flexible floorings are tested, e.g. those with a laminated structure, increased deviations from the results of the ISO 10140[4] series method may occur due to the dependency on the specimen size.
Contents:
- Foreword
- Introduction
- Scope