Watch-cases and accessories - Vapour phase deposited coatings
Introduction: This document has been developed in order to meet the global need for a definition of the requirements and tests that enable characterization of coatings applied by vapour phase deposition to watch-cases and their accessories. It defines the terms used in connection with the main vapour phase deposition processes, and presents the requirements relating to the appearance and strength of the deposited coatings, as well as their resistance to physical and chemical attack. On the conclusion of an agreement between the customer and the supplier, some latitude is left as to the choice of standard test methods and determination of acceptable limit values. This document defines a simple structure, which facilitates identification of the base material, the deposited coatings and their thickness, in order to give information to consumers. It advises manufacturers to provide these indications in the documents supplied with the watch. To protect the consumer, this document stipulates the conditions for marking watch-cases and their accessories, as well as the required compliance with ISO 3160-1, which specifies the thickness and minimum gold content for gold alloy coatings. © ISO 2017 – All rights reserved
Scope: This document specifies the general requirements and test methods for hard coatings obtained by vapour phase deposition processes intended to improve mainly the surface aspect and wear and corrosion resistance, and/or to offer protection against contact-allergy. It is applicable to watch-cases and accessories.