Acoustique - Mesurage du bruit émis par les véhicules routiers de catégories M et N à l’arrêt et en fonctionnement à basse vitesse - Méthode d’expertise
Introduction: The advent of road transport vehicles that rely, in whole or in part, on alternative drive trains (e.g. electromotive propulsion) is serving to reduce both air and noise pollution and their adverse impacts on citizens throughout the world. However, the environmental benefits achieved to date by these “hybrid or pure electric” road vehicles have resulted in the unintended consequence of removing a source of audible signal that is used by various groups of pedestrians (e.g. in particular, blind and low vision persons) to detect the approach, presence and/or departure of road vehicles. Therefore, this document has been developed to provide a method to measure the sound emission of road vehicles at standstill and low speed operation, as well as to quantify the characteristics of any external sound-generation system installed for the purpose of conveying acoustic information about the approach, presence and/or departure of the vehicle to nearby pedestrians. This document incorporates additional sensor locations and provisions to reduce the measurement variation of reported results and to introduce a metric for determining the frequency of tonal components that does not rely on prior knowledge of the sound signal. Tonal loudness calculates the audibility of the given signals considering how the sounds are perceived by people, providing an optional metric to assess detection and to identify frequency content. This document was developed in cooperation with the Society of Automotive
Scope: This document is derived from ISO 362-1[2] and specifies an engineering method for measuring the sound emitted by M and N category road vehicles at standstill and low speed operating conditions. The specifications reproduce the level of sound which is generated by the principal vehicle sound sources consistent with stationary and low speed vehicle operating conditions relevant for pedestrian safety. The method is designed to meet the requirements of simplicity as far as they are consistent with reproducibility of results under the operating conditions of the vehicle. The test method requires an acoustic environment which is only obtained in an extensive open space. Such conditions usually exist during the following: — measurements of vehicles for regulatory certification; — measurements at the manufacturing stage; — measurements at official testing stations. The results obtained by this method give an objective measure of the sound emitted under the specified conditions of test. It is necessary to consider the fact that the subjective appraisal of the annoyance, perceptibility, and/or detectability of different motor vehicles or classes of motor vehicles due to their sound emission are not simply related to the indications of a sound measurement system. As annoyance, perceptibility and/or detectability are strongly related to personal human perception, physiological human condition, culture, and environmental conditions, there are large variations and therefore these terms are not useful as parameters to describe a specific vehicle condition. Spot checks of vehicles chosen at random rarely occur in an ideal acoustic environment. If measurements are carried out on the road in an acoustic environment which does not fulfil the requirements stated in this document, the results obtained might deviate appreciably from the results obtained using the specified conditions. In addition, this document provides an engineering method to measure the performance of external sound generation systems intended for the purpose of providing acoustic information to pedestrians on a vehicle’s operating condition. This information is reported as objective criteria related to the exter