ISO 16260-2025 PDF

ISO 16260-2025 PDF

Paper and board-Determination of internal bond strength

$89.50 $179.00 -50%
Product Code: ISO 16260
Stock In Stock
Edition: 2.
Published: 12/2025
Number of Pages: 24
File Size: 1 file, 1.9 MB

Available Options

Product Description

Papier et carton - Détermination de la force de cohésion interne

Introduction: Paper and board sheets can, during printing, conversion or specific product applications, be subjected to impulses, impacts or shock loads of sufficient magnitude to cause structural failure. Commonly observed in- plane structural failures include surface picking, blistering and interior delimitation. This document describes one method for determining the internal bond strength of a product of pulp, paper or board by measuring the energy needed to delaminate a paper or board sample in the "Z" (thickness) direction. There are other published methods[4][8] for determining “Z” or thickness direction tensile strength, but in this method, the delaminating force is applied at a rate significantly higher than in other methods. This method can, therefore, be preferred for predicting sheet performance under printing or converting conditions. Different types of testers (mechanical and electronic) are in use for this method. The results obtained with the two types of testers may not be not comparable (see Clause 12). © ISO 2025 – All rights reserved

Scope: This document specifies a method to measure the energy required to rapidly delaminate a test piece of paper or board. Rupture of the test piece in the “Z” or thickness direction is initiated by a pendulum having a defined mass, moving at a defined velocity. The procedure is suitable for both single- and multi-ply papers and boards, including coated sheets and those that are laminated with synthetic polymer films. It is particularly suitable for papers and boards that can be subjected to z-direction[4][8] rapid impacts, impulses or shock loads during printing or conversion. The test procedure entails the adherence of double-sided adhesive tape to both sides of the test piece under pressure. For this reason, the method is unsuitable for materials that can be structurally damaged by compression or are porous enough to permit migration of the tape adhesive into or through the test piece.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16260-2025 PDF

ISO 16260-2025 PDF

$89.50 $179.00