Maintenance and repair of concrete structures — Part 2: Assessment of existing concrete structures
Introduction: Assessment of an existing concrete structure identifies and defines areas of distress, and verifies structural performance based on the evaluated condition of the structure. It includes the whole process from defining the work through the investigation, evaluation, verification, prediction, and registration to the final report. This is necessary as a basis for the design of the repair and the preparation of procedures to preserve or extend its remaining service life. The report, concluding the assessment, includes a description of the structure, the investigation, the results of condition assessment, the verified structural performance, the expected future development and a short presentation of possible repair principles and methods, including appropriate cost calculations. A detailed planning and design of the repair work (repair or rehabilitation project specification) is not part of the assessment, see ISO 16311-3. This document gives the requirements for assessment of concrete structures, including a framework for the assessment, a format for documentation of the condition assessment with assessed condition level and consequence level, and a format for documentation of the performance assessment with verified specific structural performance. This document is primarily based on the principles given in ISO 13822. ISO 13822:2010, Annex B has a detailed flowchart, included as Figure 1 in this document. © ISO 2024 – All rights reserved
Scope: This document describes general requirements and procedures for the assessment of concrete structures. The assessment can be initiated under the following circumstances, but not limited to: a) an anticipated change in use or extension of design service life; b) structural deterioration due to time-dependent actions such as corrosion of reinforcement, fatigue, etc.; c) safety and/or serviceability check (e.g. for earthquake and increased traffic actions) as required by authorities, insurance companies, owners, etc.; d) structural damage by accidental actions (see ISO 2394). This document does not cover — qualification of personnel; — contractual matters; — health and safety requirements for the protection of workers during the investigation and testing.