Application of statistical and related methods to new technology and product development process — Robust tolerance design (RTD)
Introduction: The designer of a product typically decides the specifications of the product and passes them on to the manufacturing section for use in manufacturing the product. The specifications include the designed nominal values and tolerances for the parts and/or elements of the product. The optimum nominal values of the design parameters are determined by robust parameter design (RPD), and the optimum tolerances are determined by robust tolerance design (RTD). RPD, as described in ISO 16336, is applied to the product prior to RTD. In RPD, the major noise factors are used to evaluate robustness as measured by the signal-to-noise ratio, which represents the variability of product output. It is a measure for comparing robustness between levels of control factors. RPD identifies the combination of the values of the design parameters as an optimum RPD condition for minimizing the variability, that is, maximizing the robustness. RTD, as described in this document, is a method for selecting the degree of errors of the parts or elements of the product from the viewpoint of variability under the optimum RPD condition, that is, the combination of optimum nominal values of the design parameters. If a manufactured product has errors from the designed nominal values, the product output will deviate from the designed value. The error in a design parameter should be smaller than the designed error limit to keep the product output within the designed variability. This is why the design parameters ne
Scope: This document specifies guidelines for applying the robust tolerance design (RTD) provided by the Taguchi methods to a product in order to finalize the design of the product. NOTE 1 RTD is applied to the target product to set the optimum tolerances of the design parameters around the nominal values. RTD identifies the effects of errors in the controllable design parameters on product output and estimates the total variance of the product output if the tolerances are changed. Hence, RTD achieves the target variance of the output from the viewpoints of robustness, performance, and cost. NOTE 2 The tolerance expresses a maximum allowable error in the value of a design parameter in the manufacturing process. In a perfect world, the parts or elements of every product have the designed nominal values of the design parameters. However, actual manufacturing does not reproduce the exact designed nominal values of the design parameters for all products. The actual products have errors in the values of their parts or elements. These errors are supposed to be within the designed tolerances.