Plastics — Thermoplastic polyurethanes for moulding and extrusion — Part 1: Designation system and basis for specifications
Introduction: This document is based on the ISO 1043 series and ISO 11469. The types of thermoplastic polyurethane are differentiated from each other by a classification system based on appropriate levels of the designatory properties: a) hardness; b) tensile modulus of elasticity (optional); and on information about the alternating hard and soft segments in the main chain, the intended application and/or method of processing, important properties, additives, colour, fillers and reinforcing materials. In order to specify a thermoplastic elastomer for a particular application or reproducible processing, additional requirements are given in data block 5 (see 4.1 and 4.6). © ISO 2025 – All rights reserved
Scope: This document establishes a system of designation for thermoplastic polyurethane elastomers. The designation system can be used as the basis for specifications. The designation system is applicable to all thermoplastic polyurethane elastomers. It applies to materials ready for normal use in the form of powder, granules or pellets, unmodified or modified by colourants, fillers or other additives, etc. This document does not intend to imply that materials having the same designation give necessarily the same performance. This document does not provide engineering data, performance data, or data on processing conditions which might be required to specify a material for a particular application and/or method of processing. NOTE If such additional properties are required, they can be determined according to the test methods specified in ISO 16365-2, if suitable.