ISO 16365-2-2014 PDF

ISO 16365-2-2014 PDF

Plastics - Thermoplastic polyurethanes for moulding and extrusion - Part 2: Preparation of test specimens and determination of properties

$48.00 $96.00 -50%
Product Code: ISO 16365-2
Stock In Stock
Edition: 1ST
Published: 05/01/2014
Number of Pages: 18
File Size: 1 file, 462 Bytes

Available Options

Product Description

Plastics - Thermoplastic polyurethanes for moulding and extrusion - Part 2: Preparation of test specimens and determination of properties

Introduction: Thermoplastic elastomer materials are classified into groups by the primary elastomeric property Hardness and with this as result of some relation with modulus, as shown in Figure 1. The classification on basis of hardness considers the special position of TPE’s between the rubber materials on the one side and the plastic materials on the other. Each class is subdivided in standard properties and special properties. The standard properties for a class are not only connected with the adjacent group(s) by many of the specified properties but also by special properties specified in the adjacent class(es). A standard property in a class can be a special property in an adjacent class and vice versa. Special properties are those properties which are in wide use or of particular significance in the practical characterization of a specific material. For each type of thermoplastic elastomer, refer to the relevant material standard. Rubber Classification of TPE's Plastic Class 1 D < 25 Class 2 25 ≥D < 65 Class 3 D ≥65 Standard properties Standard properties Standard properties Specialized properties Specialized properties Specialized properties Figure 1 — Structure of thermoplastic elastomer (TPE) material standards © ISO 2014 – All rights reserved

Scope: This part of ISO 16365 specifies the methods of preparation of test specimens and the standard test methods to be used in determining the properties of thermoplastic polyurethane moulding and extrusion materials. Requirements for handling test material and for conditioning both the test material before moulding and the specimens before testing are also given. Procedures and conditions for the preparation of test specimens in a specified state and procedures for measuring properties of the materials from which these specimens are given. Properties and test methods which are suitable and necessary to characterize thermoplastic polyester/polyurethane and polyether/polyurethane (TPU) moulding and extrusion materials, are listed. The properties have been selected from the general test methods in ISO 10350. Other test methods in wide use or of particular significance to these moulding and extrusion materials are also included in this part of ISO 16365, as are the designatory properties specified in ISO 16365‑1. In order to obtain reproducible and comparable test results, it is necessary to use the methods of preparation and conditioning, the specimen dimensions, and the test procedures specified in this part of ISO 16365. Values determined are not necessarily identical to those obtained using specimens of different dimensions or prepared using different procedures. NOTE This part of ISO 16365 has been developed on the basis of ISO 10350‑1 as at the time of publication a standard on ‘acquisition and presentation of comparable single point data’ for thermoplastic elastomers’ does not exist yet. After acceptance and publication of this part of ISO 16365, it is the intension to develop ISO 10350‑3, based on the two International Standards mentioned before, as starting point for the development of thermoplastic elastomer material standards.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16365-2-2014 PDF

ISO 16365-2-2014 PDF

$48.00 $96.00